6
Subsonic Filter with CD Horn EQ
Use settings 1, 2, and 4 from the Subsonic Filter, and setting 3 from the CD Horn Equalization Filter. This
would be suitable only if the loudspeaker system uses passive crossovers.
CD Horn boost
Subsonic roll-off
Figure 6—UF-2 as a subsonic filter with CD horn EQ
Subsonic and Ultrasonic Filter
Use settings 2, 3, and 4 from the Subsonic Filter along with 2 and 3 from the Ultrasonic filter.
Typ.
20–50 Hz
Typ. 16–
20 kHz
Figure 7—UF-2 as a subsonic and ultrasonic filter
2-Way Active Crossover
This configuration routes the frequencies below a particular frequency to amplifier Channel 1, which shall
drive the low-frequency speakers, and the frequencies above to Channel 2, which shall drive the high-
frequency speakers. Using the UF-2 as a crossover requires that you drive both amplifier inputs with the
same full-band signal.
F
c
Channel 2
Channel 1
Amp
HF Driver
LF Driver
Channel 2
Channel 1
SPA-2
Figure 8—UF-2 as a 2-way active crossover
Commentaires sur ces manuels